"The Swimbait Special"
The Complete Kit for Swimbait maintenance! Recommended for replacing tails, rips and tears gluing stinger hooks to soft plastic and even touching up hard plastic bills that have come loose. Watch our SPRO Video soon!
|Please read KICKER WARRANTY disclaimer at the bottom of this page before purchasing this product.|
Important Read for Wholesale
Purchasers and consumers of Innovative Promotion Products
LLC/PRO's Soft~Bait Glue is not liable to refund monies or replace any of the two aforementioned products or any related components for any reasons of said products to all previously mentioned parties in this paragraph and are not liable for consumer abuse and misuse, any health or injury occurrences out of consumer negligence or ignorance when not following the directions for using both PRO's Kicker and PRO's Soft~Bait Glue on substrates intended and not intended for.
By purchasing any of our Innovative Promotion, LLC Products, you the wholesale Purchaser(s), consumer(s), tackle stores and sponsored parties and the like automatically acknowledge the above paragraph titled, [Important Read for Wholesale Purchasers/consumers of Innovative Promotion Products] in its full entirety and release(s) Innovative Promotions, LLC from said paragraph content liabilities as written.
Storage: Both the
Cyanoacrylate and the Kicker accelerant need cool dry storage areas below 65
Directions & Warning for Kicker:
Directions: Apply KICKER accelerator on all material surfaces/crevices to be repaired and replace cap immediately. Let evaporate for 15 seconds. Align and hold for bonding and let glue fall to area while holding aligned materials. Instantly bonds within seconds. Do NOT touch glue tip to Primed area or hardened tip may occur and may need to soak tip in acetone to free clog. Can also be post applied. Enhances bonding of soft and hard plastic PVC plastisols, polypropylene, polyethylene's, woods, composites, delrin and other difficult materials within seconds.
Caution: Touching glue to skin coated with Kicker may cause burning sensations. Hold under cold water.
Warning: Prolonged or repeated exposure may cause irritation to eyes and skin. Vapors may be harmful, avoid inhaling and use in adequately ventilated area. If affected, seek fresh air immediately. If problem persists, contact physician. If eye contact should occur, flush thoroughly with plenty of water. Repeat several times. If skin contact occurs, wash areas with warm soapy water. If problem persists, contact a physician. If ingested do not induce vomiting. Contains synthetic hydrocarbons.
Warning: Keep glue out of reach of children. Eye irritant, bonds skin in seconds. If bonding occurs, soak in finger nail polish remover or acetone. If eyes bond, flush with water only and seek medical attention.